Cylinder Head Assembly Overview
Cylinder head, assemblyInstalling cylinder head cover, refer to Valve Cover.
1. 20 Nm (15 ft lb)
2. Intake manifold
3. 10 Nm (7 ft lb)
4. Cover
5. 10 Nm (7 ft lb)
6. Cylinder head bolt
Always replace
Tightening, refer to Specifications
7. Pressure relief valve
Replace if there are loud valve noises that affect the whole cylinder head
Replace if loosened in fitting
Secure with thread locking compound AMV 197 000 01
25 Nm (18 ft lb)
8. 10 Nm (7 ft lb)
9. Camshaft Position (CMP) sensor housing
10. Cylinder head
Checking for distortion, refer to Testing and Inspection/Procedures Testing and Inspection
Resurfacing dimensions, refer to Resurfacing Cylinder Head, Resurfacing
11. Cylinder head gasket
Always replace
Identification: lettering on gasket must face upward
Note: The single cylinder head. -10- listed can be used on either left or right sides and uses a cap to seal at the front.
Installing cylinder head sealing cap, refer to Cylinder Head Sealing Cap Cylinder Head Sealing Cap