Coding

- Beginning with October 1994 production, all 1995 m.y. Audi 100 (A6) use a new instrument cluster which includes a Service Reminder Indicator (SRI)
- The instrument cluster is coded according to the engine and country variants as well as individual, scheduled service intervals. The instrument cluster must be coded initially at the Secondary PDI (or time of delivery) and whenever a replacement cluster is installed. In addition, SRI displays must be reset after each specified service or inspection is performed.
- The system has no On Board Diagnostic capability.

NOTE: Perform the following Steps only after cluster replacement, or if the code is not as specified below

Indicated on display

Rapid data transfer HELP
Select function XX

- Press button -0- and -7- "Code Control Module" function 07.

Indicated on display

Rapid data transfer Q
07 - Code Control Module

- Press -Q- button to confirm input.

Indicated on display

Control module code
Enter code number XXXXX (0-32000)

- Input code number from code chart table below.


00 Irrelevant field
2 USA
3 Canada
6 6-cylinder engine
2 Gasoline engine

Indicated on display

Control module code Q
Enter code number 00262 (0-32000)

- Press -Q- button to confirm input.

Indicated on display

4D0919033C4 Instrument Cluster D03 ->
Coding 00302 WSC 06812

- Press - button to end coding.

Indicated on display

Rapid data transfer HELP
Select function XX

- Press button -0- and -6-to select "End Output" function 06.

Indicated on display

Rapid data transfer Q
06 - End Output

- Press -Q- button to confirm input.

Indicated on display

Rapid data transfer HELP
Select function XX