Disassembling and Assembling: Overview

Note: Refer to Removing and Installing

1. Ring gear
- Is matched to pinion (gear set)
- When gear set is replaced, ring gear and pinion must be adjusted. Refer to "List of Adjustments". Adjustments
- Heat to 100°C (212°F) and drive off differential housing with drift: refer to "Procedures"
- Use centering pins for guiding
2. Differential housing
- If replaced, adjust ring gear
3. Ring gear bolt
- Use only genuine replacement bolts
- Pull down gradually and evenly first, then tighten evenly working in a diagonal pattern
- 90 Nm (66 ft lb)
4. Sun wheels
- Installing: refer to "Procedures"
5. Planet wheels
- Installing: refer to "Procedures"
6. Differential gear shaft
- Drive out with drift after removing spring pin
7. Spring pin
- Drive out with drift
8. One-piece thrust washer
- Insert with gear oil
9. Inner race of small tapered roller bearing
- Removing and installing: refer to "Procedures" at Removing and Installing
10. Inner race of large tapered roller bearing
- Removing and installing: refer to "Procedures" at Removing and Installing
11. Speedometer gear