Track 68-78

Diagrams By Track Number

6-Cyl., Multipoint Fuel Injection, Heated Oxygen Sensor - Track 68-78:

Fuse colors
30 A - green
25 A - white
20 A - yellow
20 A - blue
15 A - red
5 A - beige


Track Continuations


Previous Diagram Track 55-67
Next Diagram Track 79-90

To Refer to
57 Tracks 55-67 Track 55-67
120 Tracks 117-123 Track 117-123


COMPONENTS
K - DLC (Data Link Connector) Rapid Data Transfer
L - DLC (Data Link Connector) Rapid Data Transfer
N18 - EGR Vacuum Regulator Solenoid Valve
N80 - Evaporative Emission (EVAP) Canister Purge Regulator Valve
G108 - Heated Oxygen Sensor (HO2S) 2
G39 - Heated Oxygen Sensor (HO2S)
S73 - Heated Oxygen Sensor (HO2S) Fuse
N71 - Idle Air Control (IAC) Valve
N156 - Intake Manifold Change-Over Valve
J192 - MFI Engine Control Module (ECM)
Z19 - Oxygen Sensor (O2S) Heater
Z28 - Oxygen Sensor (O2S) 2 Heater
J217 - Transmission Control Module (TCM)

CONNECTORS
T1a - Single Connector, near heated oxygen sensor (HO2S)
T1o - Single Connector, near heated oxygen sensor (HO2S) 2
T2 - Double Connector, white, Data Link Connector, on auxiliary relay panel 1
T2f - Double Connector, black, near heated oxygen sensor (HO2S)
T2an - Double Connector, black, near heated oxygen sensor (HO2S) 2
T6c - 6-Pin Connector, green, connector station 2
T6f - 6-Pin Connector, yellow, in electronic box, in footwell, front right

GROUNDS CONNECTIONS

NOTE: Grounds connections are indicated on the diagram by a numeric code inside a circle.

85 - Ground connection -1-, in engine compartment wiring harness

HARNESS SPLICES

NOTE: Harness splices are points inside a wiring harness where two or more wires are crimped and/or soldered together. Harness splices are indicated on the diagrams by an alphanumeric code inside a circle.

D80 - Plus Connection (87a-for EVAP system solenoid), in engine compartment wiring harness
D90 - Wire connection (RPM signal), in engine compartment wiring harness