Handset / Cradle Installation

- remove lower liner from the inside of the armrest.

Note
The armrest is pre-drilled from the factory. The cradle is attached to the driver armrest with four screws and the screws come with the cradle.

Fig. 1:

- Install rubber cushion caps into the rear cradle screw holes (arrows) (Fig. 1).





- Attach short cord mounting plate (3) to short cord (8) using the two screws (4).

- Remove split grommet (7) from armrest, route short cord (8) through armrest, attach grommet to cable, reinstall grommet.

- Secure plate and cord assembly to armrest using two screws (5) and washers (6).

- Plug short cord (8) into console socket.

- Install handset cable guide (9) to armrest lid.

- Route handset cable (11) through cable guide (9).

- Install handset (10) into cradle and connect harness.