Replacement

NOTE: "Aero" design shown.

1. Tires
- For safety reasons, tires should not be replaced individually; replace both on the same axle
- Tires with the deeper tread depth should always be mounted on the front wheels
- Use of tires from the same manufacturer, of the same model and size for all 4 wheels, is recommended
2. Valve
- Always replace when replacing wheel or tire
- Use only valve specified by the manufacturer
3. Alloy wheel
- 6J x15, ET 37
- 7J x15, ET 37
4. Wheel bolt
- 14 x 1.5 x 27.5 mm
- Tighten to: 110 Nm (81 ft lb)
5. Lock cylinder
- Install on wheel bolt and lock
6. Cap
- Install over lock cylinder
7. Cap
- Removing, refer to Fig. 1, below.
8. Adhesive balance weight
- Maximum permitted per wheel: 60 g (2 oz.)
- Installing:
- Clean wheel
- Remove protective backing
- Stick balance weight(s) onto surfaces provided





Fig. 1 Removing cap
- Clean cap with wet sponge.
- Install special tool on cap and press down.
- Remove cap.
- Loosen special tool from cap by moving the two rubber tabs sideways.