Operation CHARM: Car repair manuals for everyone.

Front







Component Notes And Information
1 Drive Axle With ABS Wheel Speed Sensor Rotor
- Outer CV joint supplied with rotor as a replacement part
- Before removing, pull out speed sensor slightly
- After installing rotor, press wheel speed sensor back in up to it's shoulder using hand pressure only
2 ABS Wheel Speed Sensor
- Same for right and left sides
- To remove, pull out from wheel bearing housing
- Ti install, press wheel speed sensor back in up to it's shoulder using hand pressure only
- Disconnect sensor harness as follows
Left front connector, refer to Fig. 1, below.
Right front connector, refer to Fig. 2, below.
- For wire harness routing, refer to Figs. 3 and 4, below.
3 Mounting Sleeve
- Always replace
- Same on right and left sides
- Coat with brake cylinder paste before installing into wheel bearing housing.
- Press into wheel bearing housing up to shoulder
4 Wheel Bearing Housing
- Supplied as a replacement part with hole for mounting ABS wheel speed sensor mounting sleeve.
5 Hex Bolt And Washer/Collar Bolt
- Always Replace
- Tighten to: 200 Nm (148 ft lb) plus an additional 90°

WARNING:
^ Fastener -5- must only be loosened or tightened with the vehicle standing on the ground
^ Risk of accident.


Procedures:





Fig. 1 Left Front Wheel Speed Sensor Harness Connector
- Disconnect coolent expansion tank and position aside
- Remove harness connector from bracket and disconnect.





Fig. 2 Right Front Wheel Speed Sensor Harness Connector
- Remove harness connector from bracket and disconnect.





Fig. 3 Wire Routing For Wheel Speed Sensor
- Install wire with grommet in retaining bracket on strut
- Clip wire onto retaining clip





Fig. 4 Wire Routing For Wheel Speed Sensor
- Install wire with grommet in retaining bracket on strut
- Clip wire onto retaining clip