Mechanical Diagrams

COMPONENT NOTES AND INFORMATION
1. Double seal
- Replacing, refer to Double (Center) Seal replacement.
2. Shim
- Behind bearing ring
- Is gauged and must not be replaced by shim of different thickness
3. Bearing ring
- Remove and install by hand
4. O-ring Always replace
- Coat with gear oil
5. Plug
- Tighten to: 30 Nm (22 ft lb)
- For checking gear oil
6. Bolt
- Tighten to: 25 Nm (18 ft lb)
- Tapered head
7. Right flange shaft
- Removing and installing, refer to Replacement.
8. Seal
- For right flange shaft
- Replacing, refer to Right Flange Shaft Seal, replacement.
9. Bolt
- Tighten to: 23 Nm (17 ft lb)
- Note tightening order, refer to Replacement.
10. Differential cover
11. Shim
- Behind bearing ring
- Is gauged and must not be replaced by shim of different thickness
12. Bearing ring
- Remove and install by hand
13. O-ring
14. Differential
15. Bolt
- Tighten to: 23 Nm (17 ft lb)
- Note tightening order, refer to Replacement.
16. Housing cover
- Illustration shows front wheel drive version
17. Dowel sleeve
18. Gasket
19. Roll pin
- For transmission selector lever
- When installing, knock into selector lever from back to front
20. Selector lever
21. Seal For selector lever
- Replacing, refer to Replacement.
22. Bolt
- Tighten to: 23 Nm (17 ft lb)
23. Seal For left flange shaft
- Replacing, refer to Left Flange Shaft Seal replacement.
24. Magnet ring For Speedometer Vehicle Speed Sensor
- Replacing, refer to Powertrain Management
25. Left flange shaft
26. Mounting bracket for left flange shaft
27. Ball bearing for left flange shaft
- Replacing, refer to Replacement.
28. Circlip
- For ball bearing
29. O-ring for left flange shaft
- Square cross-section
- To replace, remove left flange shaft and install