Control Module: Service and Repair

REMOVAL
- Remove trim from right lower A-pillar (3 in illustration).
- Remove right sill scuff molding (1 in illustration) in door area, refer to Body and Frame.
- Loosen carpeting from right inner sill panel and raise approx. 20 cm (8 in.).





- Unclip container at position (A in illustration) from top.
- Unclip container at position (B in illustration) as shown.
- Remove control module from container.
- Loosen multi-point connector, then remove connector from control module, as follows.





- Switch ignition off and wait approx. 30 seconds.
- Push lock in direction of arrow and release connector

INSTALLATION
- Install in reverse order, noteing the following additional steps:
- Check container for water penetration, seal if necessary.
- Check that clip nut (1 in illustration above) fits securely.





- Check harness routing: