Rear

Exploded View Of Rear Suspension:

LEGEND
1. Drive axle with ABS wheel speed sensor rotor
2. Wiring guide
3. Trapezoidal arm
4. Washer
5. Nut
6. Bracket for ABS wheel speed sensor wiring harness
7. ABS wheel speed sensor
8. Clamping sleeve
9. Self-locking nut
10. Bolt/washer assembly
11. Suspension strut
12. Wheel bearing housing

WARNING: To reduce risk of accident, note the following:
^ Loosen or tighten self-locking nut (9) only when the vehicle is standing on its wheels.
^ Loosen or tighten the bolt/washer assembly (10) only when the vehicle is standing on its wheels.

NOTE: During removal and installation procedures, refer to the component location illustration above and component notes below.

COMPONENT NOTES
Drive Axle With ABS Wheel Speed Sensor Rotor (1)
- Outer CV joint will be supplied with rotor as replacement part.
- Before removing, pull wheel speed sensor out slightly.
- After installing, press wheel speed sensor in by hand until seated.

Wiring Guide (2)
- Do not pinch ABS wheel speed sensor wiring harness during installation.

Nut (5)
- Tighten to 10 Nm (7 ft. lbs.).

Bracket For ABS Wheel Speed Sensor Wiring Harness (6)
- Attach to wheel bearing housing with mounting bolt for suspension strut.

ABS Wheel Speed Sensor (7)
- Left and right side sensors are identical.
- Pull out to remove.
- Before installing, coat with brake assembly lube and then push in by hand until seated.
- Both ABS wheel speed sensor harness connectors are located under the rear seat bench.

Clamping Sleeve (8)
- Before installing in wheel bearing housing, coat with brake assembly lube.
- Press into wheel bearing housing until seated.

Self-Locking Nut (9)
- Always replace.
- Tighten to 90 Nm (66 ft. lbs.).

Bolt/Washer Assembly (10)
- Always replace.
- Tighten to 200 Nm (148 ft. lbs.) plus additional 1/4-turn (90�).