Auxiliary Fuse Holders, Removing and Installing

CAUTION!
Before working on the electrical system:
- Determine the correct coding for the anti-theft radio.
- Disconnect the battery Ground (GND) strap.


Removing
- Remove fuse/relay panel cover.
- Remove (unclip) fuse/relay panel from housing (leave all connectors attached) and set aside.
- Remove fuse.
- Using a small screwdriver, release locking tab on auxiliary fuse holder.





- Pull auxiliary fuse holder upward (arrow) and out of housing.





Installing
- Slide auxiliary fuse holder into proper location until locking tab (arrow) engages.





- Install fuse.
- Re-install fuse/relay panel in housing.


NOTE: When installing the fuse/relay panel into the housing, make sure that the connector wires do not get pinched.


- Carefully install fuse/relay panel cover to ensure a tight seal against water.