Drive Plate

Removing





- Relocate 10-201 flywheel retainer to loosen and tighten bolts.
- Mark drive plate to engine.

Installing





- Install drive plate with shim -2- and mounting washer -1 -. Lug (arrow) must point toward torque converter.
- Insert at least three used mounting bolts and tighten.
Tightening torque: 30 Nm (22 ft. lbs.)





- Measure distance -a- at three places and calculate average.
Specification for Automatic Transmission 01V: 26 - 28 mm (1.024 - 1.102 inch).

If the specified value is exceeded:





- Remove drive plate and reinstall without shim -2-.
- Re-tighten bolts to 30 Nm (22 ft. lbs.).
- Repeat measurement procedure.

If specified value is obtained:
- Replace bolts and tighten.





Tightening torque