Exh. Manifold, Front Exh. Pipe & (TWC) With Attachments

Exhaust Manifold, Front Exhaust Pipe and Three Way Catalytic Converter (TWC) with Attachments





1. Spacer sleeve
2. Bolt
3. Washers
4. Bracket
5. Spacer bushing
6. Rubber bushing
7. 25 Nm (18 ft. lbs.)
8. Spring
9. Bolt
- 25 Nm (18 ft. lbs.)
10. To center muffler
11. Left-front exhaust pipe with Three Way Catalytic Converter (TWC)
- The flexpipe in left and right exhaust pipes must not be bent more than 10°, otherwise it may be damaged.
12. Heated Oxygen Sensor (H02S) 2 -G108-
- 50 Nm (37 ft. lbs.)
- Only grease threads using "G5" ("G5" must not get into slots on body of sensor)
- Checking DTC memory
- Checking components
- Checking heating function

CAUTION: Part numbers are listed here for reference only. Always check with your Parts department for the latest information.

13. 4-pin harness connectors
- Black
- Mounted to bulkhead
- For H02S and for heating function
14. 25 Nm (18 ft. lbs.)
15. Cover cap
- 10 Nm (7 ft. lbs.)
16. Connection
17. Upper heat shield
18. Lower heat shield
19. Left-side exhaust manifold
20. Gaskets
- Always replace
21. Right-side exhaust manifold
22. H02S -G39-
- 50 Nm (37 ft. lbs.)
- Only grease threads with "G5" ("G5" must not get into slots on body of sensor)
- Checking DTC memory
- Checking components
- Checking heating function

CAUTION: Part numbers are listed here for reference only. Always check with your Parts department for the latest information.

23. Right-front exhaust pipe with Three Way Catalytic Converter (TWC)
- The flexpipe in left and right exhaust pipes must not be bent more than 10°, otherwise it may be damaged.