Front

Removing
- Loosen wheel bolts.
- Raise vehicle.
- Remove wheel.





- Detach boot -1- from wheel housing.
- Separate harness connector -2- from ABS wheel speed sensor harness.
- Pull harness out of brackets (arrows).
- Remove ABS wheel speed sensor from wheel bearing housing.

Installing
- Before inserting ABS wheel speed sensor, install boot seal and grease sensor all around with assembly paste.
- Press speed sensor in by hand until fully seated.
- Connect ABS wheel speed sensor cable harness connector and press boot into wheel housing.
- After routing ABS wheel speed sensor cable (arrows), install wheel and tighten wheel bolts to 120 Nm (89 ft. lbs.).
- Turn steering to full left and full right lock and check clearance of ABS wheel speed sensor cable.