Rear

Removing
- Switch ignition off.
- Lift rear seat out of its brackets.





- Detach cable holder (right arrow), separate ABS wheel speed sensor harness connector and press out grommet (left arrow). Left and right sides are mirror images.
- Loosen wheel bolts.
- Raise vehicle.
- Remove wheel.





- Remove nuts (arrows) securing ABS wheel speed sensor harness retaining plate.





- Release ABS wheel speed sensor harness from holder (arrow).
- Pull ABS wheel speed sensor out of wheel bearing housing.

Installing
- Replace clamping sleeve, item - 4 -.
- Before inserting wheel speed sensor, install boot seal and grease sensor all around with assembly paste. Then, press in wheel speed sensor by hand until fully seated.
- Re-route sensor harness in reverse order of removal.