Handset Cradle, Installing

- Install handset cradle -1- in armrest using four threaded fasteners.

Note:
Armrest is pre-drilled at -A- for installation of handset cradle.

- Install hang up cup -2- to handset cradle
-1- using two (2.9 mm x 10 mm) screws (supplied with installation kit).

- Connect phone jack to connector -A- (located inside arm rest at right rear comer).





- Install release for phone cradle (snaps into arm rest as shown).





- Locate clip on inside of armrest cover hinge.

- Route phone cord though clip. Phone should rest in hang up cup.

Note:
Prior to use, the transceiver must be registered. To register transceiver.