Operating Switch on Multi-Function Steering Wheel

Operating Switch On Multi-function Steering Wheel, Removing And Installing

Removing
- Disconnect battery ground (GND) strap.


NOTE: Always observe airbag safety precautions when working on airbag system components


- Release steering column adjustment. Pull steering wheel as far out and up as possible.







- Remove airbag unit by removing screws at left and right of steering wheel using a T30 TORX bit. Tightening torque: 6 Nm
- Carefully flip airbag unit forward.







- Disconnect harness connectors -1- and -2- at airbag unit.
- Remove airbag unit.
- Disconnect harness connector -3- and remove both T10 TORX screws at left or right of operating switch.
- Remove operating switch toward front.

Installing


NOTE: During installation, make sure that the wires of connector -3- are in the guides and are not pinched.


- Install in reverse order of removal.