Trunk / Liftgate: Service and Repair

Tailgate, Removing And Installing

- Remove tailgate trim.
- Disconnect or remove harness connectors and hoses (i.e. for central locking and rear window washer system).
- Prop up and secure tailgate in open position.







- Using screwdriver, lift retaining spring - 3 - as shown and remove gas-filled strut - 1 - from upper ball stud - 2 -.

NOTE: Following complete removal of gas-filled strut, check for correct positioning during installation.

Sound insulation components must be installed on the body side.
- To install, press gas-filled strut onto ball studs so that it engages in position.
Ball stud tightening torque: 15 Nm - 1 Nm







- Remove hex bolt - 1 - (2x) from tailgate - 6 -.
Tightening torque: 21 Nm (15 ft.lb)