Rear Belt Adjuster, Removing and Installing

Removing


NOTE: It is not necessary to remove the rear shelf when removing the rear belt adjuster.







- Undo lower anchoring point of rear three-point seat belt.
- Tightening torque: 50 Nm (37 ft lb)
- Unclip belt guide cover -3-.
- Detach belt adjuster cover -2- at left and right of retaining tab -7-.
- Swing belt adjuster -4- with belt webbing upward.







- Use screwdriver to press retaining tab -1- (2x) inward while simultaneously pulling up on belt adjuster -2-.
- Pull belt webbing through belt adjuster -2-.

Installing







- Make sure retaining tabs -1- (2x) fully engage.
- Make sure rear lug engages in notch -6-.
- Adjustment locking device -5- must point toward center of vehicle.