Crankshaft Seal, Replacing

Toothed belt side
- Lock carrier in service position.

Ribbed belt, removing and installing. Refer to Ribbed belt, removing and installing.
Toothed belt, removing and installing. Refer to Toothed belt, removing and installing.
- Remove sealing plug from left-side of cylinder block.
- Turn crankshaft to TDC for cylinder 3. The TDC mark on crankshaft must be visible or felt behind bore for sealing plug.





- Install 3242 crankshaft holder in bore to secure crankshaft.
- Remove crankshaft/toothed belt gear.
- Unscrew inner part of 3203 seal puller two turns (approximately 3 mm) and secure using knurled bolt.





- Grease threaded head of 2085 seal puller, position and with forced pressure screw into oil seal as far as possible.
- Loosen knurled bolt and turn inner part against crankshaft until oil seal is removed.

Installing
- Place 3202/1 guide sleeve on crankshaft pin.
- Slide dry oil seal over guide sleeve.





- Press in oil seal to stop using 3265 seal installer.
The rest of the installation follows is the reverse of removal.