Oil Pump, Cylinder Block Breather and Oil Spray Jets

Lubrication system component, removing and installing (VIN 8D-W-005 001 >)
Oil pan (upper part) and oil pan (lower part), removing and installing. Refer to Oil pan (upper part) and oil pan (lower part), removing and installing.





1. Bolt
- 20 Nm (15 ft. lbs.)
2. Washer
3. Tensioner roller
- For toothed belt
4. Bolt
- 45 Nm (33 ft. lbs.)
5. Bolt
- 10 Nm (7 ft. lbs.)
- For toothed belt
6. Bolt
- 10 Nm (7 ft. lbs.)
7. Bolt
- 10 Nm (7 ft. lbs.)
8. Breather housing
9. Gasket/breather plate
- Always replace
10. Oil check valve
- 25 Nm (18 ft. lbs.)
11. Oil seal
12. Connector
13. Bolt
- 15 Nm (11 ft. lbs.)
14. 15 Nm
- For oil spray jets for piston cooling
15. Cylinder block
16. Bolt
- 10 Nm (7 ft. lbs.)
- Use locking fluid D 000 600 A2 when installing
17. Oil spray jet
- For piston cooling
18. Gasket
- Metal gasket
- Always replace
19. Engine oil temperature sensor
- 10 Nm (7 ft. lbs.)
- For oil temperature gauge
- White
- If seal is leaking, replace seal
20. Oil seal
- Replacing. Refer to Cylinder head oil seals, replacing.
21. Tensioner Compress and secure before removing. Refer to Toothed belt, removing and installing.
22. 10 Nm
- Use locking fluid D 000 600 A2 when installing
23. Washer
24. Bearing bushing
- For tensioner lever
25. Washer
26. Bolt
- 25 Nm (18 ft. lbs.)
27. Tensioning lever
28. Bearing bushing
- For tensioner roller