Wiring Between Transmission and 88-Pin Connector For TCM -J217-

Wiring Between Transmission And 88-pin Connector For Transmission Control Module (TCM) -J217-, Testing

Perform if:
- Output Diagnostic Test Mode (DTM) or
- Electrical test indicates malfunctions in the transmission, the TCM -J217-, or in the corresponding wiring.

Test conditions
- Ignition switched off
- Connect VAG1598/20 adapter only to 88-pin connector of transmission wiring harness.
- Perform measurements with VAG1598/20 adapter on the outside of the vehicle







- Remove noise insulation panel.
- Remove bracket -1- for noise insulation panel.

Wiring to 16-pin connector on transmission, testing







- Turn 16-pin connector -4- on transmission to release bayonet catch.







- Use multimeter (Fluke 83 or equivalent) to test for continuity between terminals of 16- pin connector and sockets on VAG1598/20 adapter. Resistance specifications See table.

Resistance specifications