Right (2/3) Section of Backrest, Removing and Installing

Right (2/3) Section Of Backrest, Removing And Installing







Removing
- Fold both backrest sections forward.
- Unclip trim - 3 - from rear in direction of arrow; if necessary, pry out from rear through hole.
- Remove bolt - 1 - and take off clamp - 2 -.
- Bolt - 1 - tightening torque: 10 Nm (7 ft lb)







- Lift backrest - 1 - out of center support bracket - 2 -, - arrow A - and pull off fitting - 3 -, - arrow B -.
- Disconnect connectors for heated backrest.

Installing

NOTE: Re-install grommet - 4 - if it is pulled out of outer fitting when removing backrest.

Install in reverse order of removal.