Work Procedure
Section A - Check Seat Control Module Version^ Connect VAG 1551 to vehicle and press button -1- to select "Rapid data transfer"
^ Press buttons -3- and -6- to check seat memory
^ Press -Q- button to confirm
^ Check seat memory control module version indicated on the display. Software version must be at least D05
^ If software version is correct, exit program and remove VAG 1551 as no other work is required
^ If software version is not correct, remove VAG 1551
Proceed to Section B
Section B - Install Seat Control Module
^ Move drivers seat to highest and most rearward position
^ Remove screw -1- at the front of the right side seat trim -4- of driver's seat
^ Remove screw -2- at the rear of the left side seat trim -3-
^ Raise rear of left seat trim, slide forward and remove from seat to expose seat memory control -5- and wire harnesses
^ Disconnect T6P connector (red) located under right front corner of driver's seat
^ Disconnect (2) electrical connectors at -6- and -7- of control module
^ Remove screw -8-
^ Push clip -9- in direction of arrow and remove seat memory control module and return to AoA
^ Install new seat memory control module (4B0 959 760 A version D05) and secure with screw -8- to 1.5 Nm (13 in. lb.)
^ Reinstall (2) electrical connectors into seat control module
^ Reconnect T6P (red) connector under right front corner of driver's seat
^ Reinstall left side seat trim
^ Proceed to Section C
Section C - Set seat memory basic settings in new Seat Control Module
^ Connect VAG 1551 to vehicle and press button -1- to select "Rapid data transfer"
^ Press buttons -3- and -6- for seat memory
^ Press -Q- button to confirm
^ Press --> button
^ Press buttons -0- and -8- to select "Read Measuring Value Block" function 08
^ Press -Q- button to confirm
^ Press buttons -0-, -0- and -2-
^ Press -Q- button to confirm
^ Move drivers seatback fully forward
^ Write down the numerical value shown in the display field 4
Note:
The numerical value shown in this illustration is only an example. Your value may be different.
^ Subtract 935 from the numerical value in field 4 (example 34231 - 935 = 33296 +/- 5); this will become your calibration value
^ Move drivers seatback towards sitting position until numerical value in Field 4 equals the calibration value
^ Press --> button
^ Press buttons -0- and -4- to select "Basic Setting" function 04
^ Press -Q- button to confirm
^ Press buttons -0-, -0- and -1-
^ Press -Q- button to confirm
^ The display should show "Basic Value Learned"
^ Press --> button
^ Recheck current numerical value in measuring block 2
^ Press buttons -0- and -8- to select "Read Measuring Value Block" function 08
^ Press -Q- button
^ Press -0-, -0- and -2- buttons
^ Press -Q- to confirm
^ Indicated on the display (example values) must be the average numerical value (32767) in Field 4
^ Press --> button and remove VAG 1551 from the vehicle
^ Proceed to Section D
Section D- Learning position of seatback, mechanical check
^ Move drivers seatback fully rearward
^ Press memory button (arrow) and one memory location button simultaneously (e.g., P1, P2, P3)
^ Adjust seatback forward 90 degrees
^ Press memory location button once again with driver's door open; the seatback must move back to the stop position (the seat will not move all the way back so that there is adequate rear passenger leg room)
Note:
Customer should be advised that the individual comfort positions must be reprogrammed into the seat memory!