Headlights, Removing and Installing
Headlights, Removing and Installing
Removing
- Remove front bumper.
- Remove both Torx bolts (T30) -1-.
- Remove interior Torx bolt (T30) using 1/4"-Torx-bit insert and extension.
NOTE: If necessary, use magnet to remove bolt.
- Disconnect multi-function harness connectors for headlights.
- Turn headlights -2- toward center of vehicle and remove from chassis toward front.
Installing
Installation is reverse of removal, noting the following:
- Adjust dimension -a- via plastic bolt at new headlight.
NOTE: Determine dimension -a- at plastic bolt of old headlight, when being replaced.
- Engage headlight in area of center of vehicle in guide -2- via pin -1-.
- Always align headlight according to contours of chassis (gap dimensions) and secure.
- Adjust headlight after installing.
Tightening torque
Component Nm
Headlights to lock carrier 6