Link Guide With Cable, Removing and Installing

Link Guide With Cable, Removing And Installing

- Sunroof removed
- Sunroof motor removed

Removing
- Slide link guide evenly on both sides toward rear into guide rail.







- Remove screws at guide profile.
Tightening torque: 2 Nm (18 in.lb.)
- Remove guide profile.
- Slide link guide forward and out of guide rails.
- Remove screws on left and right trim panels and remove trim.







- Rain channel - 1 - is attached to link guide - 2 - on left and right with clips. Pry clips off before removing.
- Raise rain channel - 1 - in link guide - 2 - and pull out in direction of arrow.
- On vehicles with glass panel, disconnect catch strap on rain channel.
- Remove link guide and cable.

Installing
Installation is the reverse of removal, noting the following:

NOTE: Install rain channel first before installing the link guides.







- Position rain channels in frame in direction of arrow and push in toward rear.