Oil Cooler: Service and Repair

Oil filter/oil cooler

NOTE: During removal and installation procedures, refer to the component location illustration above and component notes below.

Component Notes And Information

NOTE: Always replace gaskets and seals.

1 Bolt, tighten to: 20 Nm (15 ft lb)
2 Coolant Line (drain)
3 Bolt, tighten to: 10 Nm (89 inch lb)
4 Bolt, tighten to: 25 Nm (18 ft lb)
5 Bolt, tighten to: 50 Nm (37 ft lb)
6 Oil Seal
7 Oil Filter Cap
8 Oil Filter Element
9 Bolt, tighten to: 10 Nm (89 inch lb)
10 Valve Plate
- Includes pressure relief valve for oil filter and oil cooler
11 Oil Seal
12 Bolt, tighten to: 50 Nrn (37 ft lb)
13 Oil Seal
14 Housing
15 Oil Pressure Switch
- 1.8 bar (26 psi)
- White insulation
16 Oil Pressure Switch
- 0.3 bar (4.35 psi)
- Brown insulation
17 Bolt, tighten to: 25 Nrn (18 ft lb)
18 Oil Seal
19 Oil Cooler
- Immersed in coolant
20 Oil Seal
21 Housing For Oil Cooler
- With coolant drain plug
22 Oil Seal
23 Pipe Fitting
- Coolant supply ine
24 Oil Seal
25 Oil Seal