Knee Bar and Bracket, Driver Side, Removing and Installing

1 - Knee bar
- For driver side
Removing:
- Remove lower gap cover -6- from below.
- Pry out left trim -2- and right trim -3- using screwdriver.
- Remove screws -4- and -5- and remove kneebar.
2 - Trim, left
3 - Trim, right
4 - Screw
- 2.5 Nm (22 in. lb)
- Qty: 3
5 - Screw
- 2.5 Nm (22 in. lb)
- Qty: 2
6 - Gap cover, lower
7 - Support, left
- Removing instrument cluster. [1][2]Procedures
- Control module for ABS
- Remove screws -9-.
8 - Support, right
- Removing instrument cluster. [1][2]Procedures
- Air duct for side air outlet rear, removing and installing See Fig. 1
- Remove screws -10-.
9 - Screw
- 15 Nm (11 ft lb)
- 2 parts
10 - Screw
- 15 Nm (11 ft lb)
- 2 parts
11 - Bracket
- Remove screw -12-.
12 - Screw
- 2.5 Nm (22 in. lb)

Fig. 1 Removing and installing air vent for side outlet, rear







- Remove screw -1-.
- Slide airduct -2- out completely in direction of left arrow until air duct unhooks from A/C.
- Remove air duct downward (in direction of arrow).
- Disconnect connector for floor outlet light -3-.
- Area -4- is removed on vehicles with manual transmission.