5 Speed Automatic 01L AWD

Code Control Module (Scan Tool Function 07)

- Connect VAG1551 scan tool, insert "Transmission Electronics" address word 02, and advance through program sequence until "Select function XX" is displayed. Connecting VAG 1551 Scan Tool

Indicated on display


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -7- to select "Code Control Module" function 07.


NOTE:
The Transmission Control Module (TCM) can be successfully coded only with:
- Ignition switched on
- Gear selector lever in "P" or "N" position
- Accelerator pedal at Closed Throttle Position (CTP)
- Vehicle not moving
- Engine not running


Indicated on display


Rapid data transfer Q
02 - Transmission Electronics


- Press -Q- button to confirm input.

Indicated on display


Code Control Module HELP
Input code number XXXXX


- Input code number according to table.







- Press -Q- button to confirm input.


NOTE:
- Other codes are not permitted.
- After coding, DTC memory is automatically erased.


- Press -> button.

Indicated on display

Rapid data transfer HELP
Select function XX


- Press buttons -0- and -1- to select "Check control Module Versions" function 01, and press -Q- button to confirm.

Indicated on display (example)


4D0927156K AG5 01L 4,21 4V USA D29
Coding 00002 WSC 01268


- Check coding (refer to table).

If indicated on display:


Malfunction ->
Coding XXXXX not accepted!


NOTE:
- The code that was entered is invalid, or is not recognized by the TCM.
- If an invalid code has been entered, the TCM will retain the old coding.
- Only older VAGl551 program cards will display the TCM identification with the old coding after an invalid code has been entered.


If indicated on display:

Function is unknown or ->
cannot be carried out at the moment


An attempt has been made to input coding under conditions that do not permit it (e.g. transmission drive mode selected).