With Forged Alloy Wheel

Component Notes And Information

NOTE: During service procedures, refer to the illustration above and the information below.

1 Tire
- For safety reasons, do not replace individually; change both on the same axle
- Tires with greater tread depth should always be installed on front wheels
- Install only tires of same make, type and tread pattern on all wheels
- Tire size, refer to Specifications.
2 Valve
- Always replace when replacing wheel or tire
3 Forged alloy wheel
- 7J x 16
- 42 mm offset
4 Wheel bolt/locking wheel bolt
- Tighten to: 120 Nm (89 ft lb)
- Anti-theft wheel bolt refer to Fig. 1, below.
- M14 x 1.5 x 27.5 mm
5 Lock cylinder
- Install on locking wheel bolt, then cover
6 Cover
- Place on lock cylinder
7 Cap
8 Adhesive-backed balancing weights
- Maximum 60 grams (2.1 oz.) approved for each wheel
- Installing:
Clean wheel (remove oil and grease)
Remove protective backing
Stick balancing weights onto cleaned surfaces at required positions

Procedures





Fig. 1 Anti-Theft Wheel Bolt
1 - Anti-theft wheel bolt
2 - Cap
3 - Wheel bolt adapter