With Manufacturers Scan Tool

Check DTC Memory (Function 02)


NOTE: The displayed DTC information is not constantly updated but only when initiating the On Board Diagnostic (OBD) or with the function 05 "Erase DTC Memory".


- Starting interior monitoring system On Board Diagnostic (OBD). On Board Diagnostic (OBD), Initiating

Indicated on display:


Rapid data transfer HELP
Select function XX


- Enter "02" "Check DTC Memory" function and confirm entry with Q key.

Indicated on display:


No DTC recognized!


- Press -> key.

or

Indicated on display:


X DTC recognized!


The stored DTCs are displayed and printed in sequence when the printer is switched on.


NOTE: If the printer is switched off, press the key to display the next DTC.


- Press key after the last DTC is displayed and printed.

Indicated on display (function selection):


Rapid data transfer HELP
Select function XX


- Repair printed malfunctions according to DTC table, then erase DTC memory and interrogate the DTC memory again as a check.