Erase DTC Memory and End Output (Function 05 and 06)

NOTE: DTC memory can be erased only after it has been checked. If DTC memory cannot be erased, again check DTC memory and repair any malfunctions.


Requirements
- DTC memory checked.
- All malfunctions repaired

When DTC memory has been checked:

Indicated on display


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -5- to select "Erase DTC Memory" function 05.

Indicated on display


Rapid data transfer Q
05 - Erase DTC Memory


- Press -Q- button to confirm input.

Indicated on display


Rapid data transfer ->
DTC Memory is erased!


DTC memory is now erased.

- Press -> button.

Indicated on display


Rapid data transfer HELP
Select function XX


NOTE:
- This message indicates an error in the test sequence.


Attention! ->
DTC Memory is not interrogated


- This message indicates an error in the test sequence.


Rapid data transfer ->
DTC Memory is not interrogated


- Adhere exactly to the test sequence: first check DTC memory, repair malfunctions as necessary, then erase DTC memory.


End Output (scan tool function 06)

- Press buttons -0- and -6- to select "End Output" function 06.

Indicated on display


Rapid data transfer Q
06 - End Output


- Press -Q- button to confirm input.

Indicated on display


Rapid data transfer HELP
Insert address word XX


- Switch ignition off.
- Disconnect VAG1551 Scan Tool (ST) from Data Link Connector (DLC).