B-Removing and Installing Rear Three-Point Seat Belt

- Remove side trim.
- Remove sill panel trim.
- For vehicles with automatic seat belt tensioner, disconnect retractor cable tube.

1 - Spacer
2 - Shouldered nut
- 50 Nm (37 ft lb)
- Move belt relay slightly when tightening shoulder nut on screw
3 - Cap
- Pry off of belt relay
4 - Side trim
5 - Bolt
- 50 Nm (37 ft lb)
6 - Bolt
- 50 Nm (37 ft lb)
7 - Washer
8 - Guide bracket
9 - Grommet
10 - Retractor for three-point seat belt, rear
- When installing, locking lug must go through cutout (arrow)
11 - Coupling tube