Front Final Drive, Servicing

Front final drive, servicing

- Transmission installed

Notes
General repair notes, Refer to General Repair Instructions General Repair Instructions
Rules of cleanliness for working on automatic transmissions, Refer to Rules of Cleanliness For Working on Automatic Transmissions Rules of Cleanliness For Working on Automatic Transmissions






1. Seal
Betwwen final drive and transmission housing
Always replace

2. Adjustment shim
Behind tapered roller bearing outer race

3. Tapered roller bearing outer race

4. O-ring
Always replace

5. Locking bolt 30 Nm
6. Bolt 23 Nm
7. Right drive flange


8. Seal
For right drive flange
Always replace refer to Right Flange Shaft Seal, Replacing Right Flange Shaft Seal, Replacing

9. Bolt 23 Nm
Observe tightening sequence

10. Cover for final drive

11. Adjustment - shim
Behind tapered roller bearing outer race

12. Tapered roller bearing outer race

13. O-ring
Always replace

14. Differential

15. Bolt 23 Nm
Observe tightening sequence

16. Cover for front final drive
Front Wheel drive version shown here

17. Bushing

18. Gasket
Always replace

19. Spring dowel sleeve

20. Lever
For shift rod

21. Seal
For shift rod
Always replace

22. Bolt - 23 Nm

23. Seal
For left drive flange
Always replace

24. Drive gear
For Speedometer Vehicle Speed Sensor (VSS) -G22-

25. Left drive flange
Removing and installing refer to Seal and Grooved Ball Bearing For Left Drive Flange, Replacing Seal and Grooved Ball Bearing For Left Drive Flange, Replacing

26. Mounting bracket for drive flange

27. Grooved ball bearing for drive flange
Always replace

28. Snap ring

29. O-ring
Square cross section
Remove and install left drive flange to replace