"Up to VIN 8D XA 200 000"

Rear Bumper, Removing, Installing And Assembly Overview (> VIN 8D XA 200 000)







1 - Metal bolt
2 - Bracket
- To remove, remove metal bolts - 1 - and take off bracket.
3 - Clip
4 - Spoiler







5 - Bumper
- Before removing, remove rear panel trim.
- Remove tailgate seal in area of loading edge/side panels.
- Fold luggage compartment cover forward.
- Remove tie-downs left and right at side trim and unclip rear side trim.
- Carefully pull side trim at left and right towards vehicle interior.
- Remove combination bolts - 9 -.
- Unclip bumper from bracket - 2 - in direction of arrow and pull off towards rear.
6 - Bracket
7 - Cover strip







8 - Support
- To remove, heat body with heat gun to approx. 40 degrees C (104 degrees F) and pull off support.
- To attach, heat body in adhesion area with hot air injector to approx. 40 degrees C (104 degrees F).

- Adhesion surface must be free of dust and grease

- Pull off protective foil and press on support using special tool 3356 (application roller).
9 - Combination bolt
- 23 Nm (17 ft.lb)
10 - Console