Input Shaft/Pinion/Hollow Shaft/Shift Rods/Trans, Diff. Cover

1. Transmission housing
2. Input shaft
3. Shift rod with shift fork for 3rd and 4th gear
4. Left stop bolt
- 40 Nm (30 ft. lbs.)
5. Sealing washer
6. Relay shaft
7. Sealing washer
8. Right stop bolt
- 40 Nm (30 ft. lbs.)
9. Shift rod
10. Shift detent
11. Torx bolt
- 25 Nm(18 ft. lbs.)
- With shoulder to secure shift detent spring
12. Shift rod with 1st/2nd/5th and reverse gear shift fork
13. Drive pinion with hollow shaft
14. Transmission cover
15. Torx bolt
- 22 Nm (16 ft. lbs.)
16. Compression spring
17. Torsen differential cover
18. Torx bolt
- 22 Nm(16 ft. lbs.)





Fig. 1 Removing and installing oil collector tray

Removing
- Turn oil collector tray (arrow) and pull out.

Installing
- Push oil collector tray into transmission, until it snaps in.
Oil collector tray faces upward in transmission cover.