Dual-Mass Flywheel or Driveplate, Removing and Installing

Dual-Mass Flywheel

Notes:
- Only replace oil seal with sealing flange.
- Drain coolant before removing sealing flange. Refer to Cooling system, draining and refilling.

If sealing flange is not available, proceed as follows:
- Remove clutch and dual-mass flywheel or driveplate.





- Pry out seal using 10-221 extractor.
- Clean running and sealing surfaces.
- Push seal onto crankshaft using assembly aid.

Notes:
- Do not lubricate sealing lip or outer edge of seal before pressing in.
- The assembly aid is supplied with the seal.





- Press in seal up to stop using 2003/3 seal installer and bolts for dual-mass flywheel or driveplate.

Dual-mass flywheel pilot needle bearing, removing and installing





- Remove pilot needle bearing using puller -A- (e.g. KUKKO 21/2 and KUKKO 22/1).
- Install bearing using 3264 bearing driver.