Basic Setting (Function 04)

Basic setting (function 04)
- Connect Scan Tool VAG1551 or 1552, enter address word 08 "A/C Heating Electronics" and move forward in program until "select function XX" appears in the display.
- Switch on printer by pressing the PRINT button (indicator lamp in the button comes on).
- Check DTC memory and repair all malfunctions which are displayed With Manufacturer's Scan Tool
- Erase DTC memory DTC Memory Erasing (Function 5)
- Check coding and re-code if necessary Programming and Relearning

Indicated on display (function selection)


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -4-.

Indicated on display


Rapid data transfer Q
04 - Basic Setting


- Press -Q- button to confirm input.

Indicated on display


Start basic setting HELP
Input display number XXX


- Press buttons -0- and -1-.
- Press -Q- button to confirm input.


NOTE:
The following flap motors are actuated in sequence and end positions are stored in A/C control head -E87-:
- Temperature Regulator Flap Motor -V68-
- Central Flap Motor -V70-
- Footwell/Defroster Flap Motor -V85-
- Air Flow Flap Motor -V71-

End positions are determined from resistance values of potentiometers installed in the air/temperature flap flap motors.


Indicated on display


Basic setting 1
XXX XXX XXX XXX


Indicated on display


Basic setting 1
0 0 0 0


When all display fields indicate "0", basic setting is ended.
- Press -> button.


NOTE:
- For m.y. 1996, because A/C engine coolant temperature sensor G110 is not installed on USA/CDN models, during basic setting, DTC "00799 engine coolant temperature sensor G110" is stored and must be erased.
- For m.y. 1997 A/C engine coolant temperature (ECT) sensor -G110- is deleted, and will no Longer load a DTC when checking DTC memory after ending basic setting.
- Check DTC memory With Manufacturer's Scan Tool
- Erase DTC memory (function 05) and end output (function 06) DTC Memory Erasing (Function 5), End Output (function 6)