Throttle Valve Control Module Power Supply, Checking

Throttle valve control module power supply, checking







- Disconnect 8-pin harness connector from throttle valve control module -J338-.
- Connect multimeter US1119 (Fluke 83 or equivalent) between harness connector terminals using adapter cables from VW1594 connector test kit.
- Switch ignition on, and check voltage. Specified values:
- Connector terminals 3 and 7 (Ground): 9.0-14.5 volts
- Connector terminals 4 and 7 (Ground): 4.0-6.0 volts
- Switch ignition off.

If voltage is NOT OK:
- Connect VAG1598/22 test box. Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks/Connecting VAG 1598/22 Test Box" Testing and Inspection
- Check wiring for open circuit between ECM/test box and 8-pin harness connector.
- Connector terminal 3 to ECM/test box socket 69
- Connector terminal 4 to ECM/test box socket 62
- Connector terminal 7 to ECM/test box socket 67
- Specified value: max. 1.5 Ohms







- Check wiring for short circuit between ECM/test box and 8-pin harness connector.
- Connector terminal 7 to ECM/test box socket 69
- Connector terminal 7 to ECM/test box socket 62
- Connector terminal 4 to ECM/test box socket 67
- Specified value: Infinity Ohms
- Reconnect throttle valve control module harness connector.

If wiring is OK:
- Replace Motronic Engine Control Module (ECM) -J220-.
- Carry out adaptation of throttle valve control module to ECM.
- Check readiness code. If Diagnostic Trouble Code (DTC) memory has been erased, or ECM was disconnected, generate new readiness code.
Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/Checking Readiness Code" Testing and Inspection
Refer to "Monitors, Trips and/or Drive Cycle (Readiness Codes)/Generating Readiness Code" Testing and Inspection