Oil Pump Chain Sprocket on Crankshaft Replacement

Oil Pump Chain Sprocket on Crankshaft, Removing and Installing
Removing
Front sealing flange and oil pump chain, removing and installing.





- Using puller -2-, remove crankshaft chain sprocket, while protecting crankshaft end with appropriate washer -1-.

Installing
- Warm chain sprocket in 220°C (428°F) oven for approximately 15 minutes.

WARNING: Wear protective gloves.

Note: Installation position: wider collar of chain sprocket points toward engine.





- Using pliers, install chain sprocket on crankshaft end and slide onto crankshaft to stop using 30-100 press tube. If necessary, carefully tap with plastic hammer.