Three-way Halogen Headlights, Overview

Three-way Halogen Headlights, Overview

CAUTION! Disconnect the battery Ground (GND) strap before working on the electrical system.

NOTE:
Before disconnecting the battery, determine the correct coding for the anti-theft radio.
After reconnecting the battery, check and activate the vehicle's electrical equipment (radio, clock, comfort and convenience features, etc.).
Some procedures could affect the headlight beam adjustment, requiring that it be reset. Refer to Adjustments Adjustments

Adjusting spray for headlights washer nozzles, refer to Wiper and Washer Systems - Headlamp Washer Spray Nozzle - Adjustments Adjustments







1. Diffuser lens

2. Retaining clamps (7x)
To remove, carefully pry out using screwdriver
To install, press in by hand

3. Headlight frame
Locked within headlight housing

4. Seal for lens
Always replace

5. Reflector
To remove, clip out of retaining rings
To install, carefully press into retaining rings
Do not touch inside of reflector

6. High beam bulb
12 V 55 W (H7)

7. Front fog light bulb
12 V, 55 W (H1)

8. Low beam bulb
12 V, 55 W (H7)

9. Wiring with harness connector

10. Trim strip
Clipped onto headlight housing

11. Fixed bearing for reflector
Only on vehicles without headlight automatic vertical aim control

12. Cover
Press lock down and remove toward rear

13. Headlight - housing
14. Bulb socket

15. Turn signal bulb
12V, 21 W orange

16. Turn signal lens
Removing and installing refer to Turn Signals - Service and Repair - Procedures Service and Repair