Headlamp: Service and Repair

Headlights, Removing And Installing

NOTE: Protect bumper using cloth backed tape in headlight area to prevent damage to paint.

Removing

- Remove turn signal. Refer to Turn Signals - Service and Repair - Procedures Service and Repair






- Remove bolt (arrow) 6 Nm (53 in lb)






- Remove two bolts (arrows) 6 Nm (53 in lb)
- Disconnect headlight harness connector.
- Disconnect headlight beam adjusting motor harness connector.






- Pull headlight out from peg mount at side (approx. 15 mm), lift slightly and then lift out carefully toward front, rotating if necessary.

Installing

- Install in reverse order of removal.
- Always align headlights to adjacent body panels (gap clearances) before securing.
- Adjust headlights after assembly. Adjustments