Upper Control Arm Sheet Steel Upper Control Arm, Servicing

1. Bonded rubber bushings
^ Pressing out refer to Fig. 1
^ Pressing in refer to Fig. 3
2. Upper control arm
^ Replacement part supplied with bonded rubber bushings installed
^ Left and right-side components are identical
3. Bonded rubber bushing
^ Pressing out refer to Fig. 2
^ Pressing in refer to Fig. 4
^ Bushing may be installed with slots in bushing aligned in any direction

Fig. 1 Pressing bonded rubber bushings out of upper control arm





If VW416B tube, 37 mm dia. becomes canted while pressing out, relieve pressure and start over.

CAUTION: Be careful not to damage the surface of the upper control arm.

Fig. 2 Pressing bonded rubber bushing out of upper control arm




Note: 41-501 tubular section must be exactly in the correct position.

Fig. 3 Pressing bonded rubber bushings into upper control arm





- Position bonded rubber bushing perpendicular to upper control arm.
- Press bushing fully in up to stop.


Fig. 4 Pressing bonded rubber bushing into upper control arm





- Press bushing fully in up to stop.