Function Selection Switch II, -E272-, Removing and Installing

Function Selection Switch II, In Center Console -E272-, Removing And Installing







Removing
Function selection switch -1- is located in the center console beside the parking brake lever.


NOTE:
During removal, the function selection switch can only be removed from panel straight upward. During this process, function selection switch may not be tilted or turned, otherwise the catches on bottom side break off.


- With two screwdrivers at trim -arrows- carefully lever out function selection switch -1- and remove from panel upward.
- Disconnect 4-pin harness connector at function selection switch.

Installing:
- Install in reverse order of removal.