Output Diagnostic Test Mode (DTM) (Function 03)

Output Diagnostic Test Mode (Scan Tool Function 03)

Automatic vertical headlight aim control system


NOTES:
- The output Diagnostic Test Mode (DTM) can only be carried out on a stationary vehicle.
- If a malfunction is found during the output DTM, trace the cause and replace the malfunctioning part.


The following tests are carried out by the output DTM:
- Lowering headlights
- Raising headlights

Test requirements
- Low beams switched on

Initiating output DTM
- Press buttons -0- and -3- to select "Output Diagnostic Test Mode" function 03.

Indicated on display


Rapid data transfer Q
03 - Output Diagnostic Test Mode


- Press -Q- button to confirm input (output DTM for headlight vertical headlight aim control system is started).

Indicated on display


Output Diagnostic Test Mode ->
Lower head lights


Headlights will be lowered until sequence is switched ahead or the lowest position is reached.

- Press -> button.

Indicated on display


Output Diagnostic Test Mode ->
Raise head lights


Headlights will be raised until sequence is switched ahead or the highest position is reached.

- Press -> button.

Indicated on display


Output Diagnostic Test Mode ->
END


- Press -> button.

The scan tool returns to the "Select function XX" mode.

Indicated on display


Rapid data transfer HELP
Select function XX