Shift Mechanism, Disassembling and Assembling

5 Speed Automatic 01V

Shift Mechanism

Disassembling
- Remove shift mechanism.
- First remove the stop buffer from shift cable lever.
- Move selector lever into Tiptronic gate and remove frame.
- Move selector lever to "2".
- Lift lever for lock cable and disengage from from its mounting and remove from mounting bracket.
- Move selector lever to "D".
- Carefully lever spring for Tiptronic position from the outside from mounting bracket
- Remove clips for bushings of selector lever.
- Press out mounting bushings for selector lever toward the outside, using a screwdriver.
- Remove complete selector lever.
- Disassemble selector lever.
- To remove mounting for Tiptronic position of selector lever, disengage clips on outside of mounting bracket and remove mounting from inside.
- Press out bolt for locking pawl using a drift.
- Remove shift lock solenoid switch together with locking pawl upward.
- Carefully lever out lock spring for selector lever positions from the outside of mounting bracket.
- Remove both retaining bolts of selector lever cable and detent.
- Pull out selector lever cable and detent by opening detent upward from mounting bracket.
- Unclip detent from cable lever.

Installing:
- Clip detent to cable lever.
- Slide cable lever and detent from above with opening of detent into mounting bracket.
- Drive in both mounting bolts for cable lever and detent from both sides into mounting bracket.
- Press in spring and roller for selector lever position into mounting inside of mounting bracket to stop.
- Insert shift lock solenoid together with locking pawl from above into mounting bracket.
- Carefully drive in bolt for locking pawl.
- Mechanically check engagement of locking pawl in "P" and "N" using screwdriver.
- Insert complete selector lever into mounting bracket.
- Attach selector lever at top and bottom into cable lever.
- Slide in both mounting bushings for selector lever from the front or rear into the mounting bracket.
- Install locking plates for mounting bushings into mounting bracket with angled sides pointing toward the inside.
- Push spring for Tiptronic position in its attachment in mounting bracket to stop.
- Move selector lever to "2".
- Insert locking pawl in mounting bracket and engage both (you must feel engagement).
- Check locking function of locking pawl: Locking pawl must engage in detent in "P" and lock selector lever.
- Install frame on mounting bracket (ribbed side faces up) and insert stop buffer on selector lever cable
- Install shift mechanism.