Rear Window Wiper, Removing and Installing

NOTE: Before removing the wiper arm, make sure that the wiper motor is in the park position.


1 - Wiper blade
2 - Cap for rear wiper
3 - Nut
- Number 13, 16 Nm (12 ft lb)
4 - Spring washer
5 - Wiper arm
6 - Rear washer jet
7 - Shaft for rear wiper
8 - Wiper blade rubber

Removing
- Carefully pry off cap -2- using small screwdriver.
- Loosen nut -3-.
- 16 Nm (12 ft lb)
- Remove nut -3- and spring washer -4-.
- Remove wiper arm -5- from shaft for rear wiper -7-.

Installing


NOTE: Before installing, make sure that the switch for the wiper motor is in the position.


- Place wiper arm -5- together with wiper blade -1- onto shaft for rear wiper.
- Install wiper blade rubber -8- in park position with ends of wiper blade 5 mm from ceramic with full pressure.
- Secure wiper arm -5- with nut -3-.
- Activate rear wiper.
- If necessary re-align wiper arm and tighten nut.
- 16 Nm (12 ft lb)