Rear Bumper, Assembly Overview

Rear Bumper, Assembly Overview







1 - Nut
- 2 pieces
2 - Bracket
3 - Screw
- 12 Nm
- 2 pieces
- Unscrew inside luggage compartment
- Remove grommet
- Bolt at right is not accessible until battery is removed
4 - Gliding piece
- Removing Fig. 1







5 - Impact absorber
Removing:
- Remove bumper.
- Remove hex bolt - 6 - and pull impact absorber out of long member.
6 - Hex bolts
- 23 Nm
7 - Right trim
- Remove and install as done for front trim
8 - Center trim
- Remove left and right trim before removing
9 - Clip
- To remove, unclip bumper carrier







10 - Bumper carrier
Removing:
- Remove bumper.
- Unclip expanding clips.
11 - Bumper cover
- Can be replaced individually
12 - Rear spoiler
- Can be replaced individually
13 - Cylinder bolt
- 65 Nm

Fig. 1 Removing Guide







- Bumper removed
- Remove hex nuts - 1 - and take off guide.
- When installing, tighten hex nuts to 2 Nm.