Oil Pump Drive

NOTE:
^ During removal and installation procedures, refer to the component location illustration above and component notes below.
^ Seals and gaskets should always be replaced.
^ All of the components shown on the illustration can be removed and installed with the engine installed.

Component Notes And Information

1 Oil Seal, Oil Pump Drive
2 Oil Seal, Crankshaft
3 Oil Pump Drive
4 Bolt, tighten to: 10 Nm (89 inch lb)
5 Bolt, tighten to: 80 Nrn (59 ft lb)
6 Bolt, tighten to: 35 Nrn (26 ft lb)
7 Bolt, tighten to: 10 Nrn (89 in. lb)
8 Circlips
9 Plug, tighten to: 5 Nm (26 ft lb)
10 Oil Retention Valves
- Replacing, refer to Replacement. Service and Repair