Sunroof Panel Height, Adjusting

Sunroof Panel Height, Adjusting

Vehicles With Aluminum Sunroof Panel







Adjust height at front and rear as shown to avoid wind noise.
- Check height adjustment at center of front and rear edges of roof opening.

- vorn = front
- Front edge of roof panel should not be higher than the roof opening along any point.
- The rear edge of the roof panel should not be lower than the rear edge of the roof opening along any point.
- To adjust height, always close sunroof from the open position.

Vehicles With Solar (e.g. glass) Sunroof Panel







NOTES:
- If the car is equipped with a glass panel, the height of the panel must be measured from the top of the panel seal.
- In this case, the weatherseal of the panel should not be higher at the front or lower at the rear than the roof at any point.
- - A - = front







- To adjust front height, loosen screws - 1 - and - 2 -.
Tightening torque: 4.5 Nm (40 in.lb.)

Rear Height Adjustment

- To adjust rear height, loosen screws - 2 - and - 3 -.
Tightening torque: 4.5 Nm (40 in.lb.)
- Adjust height as shown in illustrations.